How to Put in a Dimmer Switch

Putting in a dimmer switch is just as easy as installing a single-pole switch, plus adjustable overhead lighting is a fantastic enhancement that contributes appeal to any house.

Switch Off The Electricity

Turn off the electricity to the circuit at the circuit breaker or fuse box. Make sure to ensure that it absolutely was switched off by flicking the switch in an attempt to operate a light, and by employing a voltage tester to confirm the cables within the box are not charged as soon as the switch cover happens to be extracted.

Remove Current Switch and Plate

Utilize a flathead screwdriver to take out the switch cover, along with a Phillips head screwdriver in order to detach the switch in the box.

Remove any Electrical wires Within the Old Switch

Make use of a screw driver all over again for you to ease the screws holding the electrical wires along the side of the switch, and then separate the wiring within the switch. Pay close attention to the wire colors where they were linked on the old switch, since they will become important in the following step. Maintain your wires separated by bending these to opposite corners of the box. If ever the switch is grounded, take away the grounding wire last.

Utilizing needle nose pliers will probably be useful although working in this little space.

Place any Wires Towards The Dimmer Switch

Generally there will be 3 wires: one black, one white, along with a separate ground wire which might be bare copper or is sometimes covered with green. Find out the various colored wires, and connect the wires towards the dimmer just like they were coupled to the switch. If your wires are solid copper, develop a loop eventually of the wire together with the pliers and guide it around the screw on the side of the dimmer. Tighten up the screw, making certain the wire is safely and securely held beneath the screw and is not splaying in to the perimeter of the screw. Should your wall wire comprises a group of smaller wires, makes use of the pliers to carefully twist the ends of the wires together to make them “whole,” and then follow the same direction.

Connect the Dimmer Switch to the Box and then Reinstall the Switch Plate

Once the wires have been attached, you are able to softly fold any kind of excessive wire and compress the dimmer into the electrical box. Move slowly to be sure the wires don’t weaken or separate if you should force the switch in place. Tighten the screws to be able to secure the switch to the box, as well as fit the switch plate. You will find that tightening or loosening the switch screws in the box by a few small twists makes a difference with how well the plate fits over the box. As soon as the cover is in place, switch the breaker or fuse back on, and look your work!

Certainly not all lights are meant for use with dimmer switches - a bad blend can damage the light bulb along with the dimmer electronics. The bulb's packaging will most likely indicate if it is dimmable.